Instructions for Lighted Valkyrie Wings

  1. The ground wire out of the light hooks on the mounting bolt of the light.
  2. The switch mounts in the left side cover by the front corner of the seat.
  3. The relay sits underneath the seat near the battery.
  4. The accessory wire that is under the right side cover is light green with a red stripe. This is the one that goes to the switch. The all green wire is the ground wire. Don't worry about that one.
  5. One of the wire harnesses hooks to the power wire out of the lights. You will need to cut it to the right length so that it hooks and unhooks by the neck of the bike. This will enable you to easily remove the lights.
  6. The other wire harness comes from the relay to the same place by the neck of the bike.
  7. pictures will be on the web site to help show the hook up.

No plastic flange covers are needed on the metal wind deflectors where the bolt holes are located.

Some photos of this install which may help are available HERE ....

If I can be of any further assistance, please call me.
Thanks,
Wayne (253) 841-8594

deflector diagram 1

deflector diagram 2

Home Page | Deflector page